Monitor Force & Protect Investments
The TQM is important for powdered metal, compaction, insertion, staking and in-die applications. It is used with "in-line" load cells and strain gauges. Die setup, SPC work and quality assurance are made easier when using a TQM Tonnage Monitor. Not only will it monitor force, but it will assist in protecting your investments by reducing downtime, improving productivity and improving product quality.
| Standard | Option | |
| Manual alarm setpoints | ✓ | |
| Automatic setpoints | ✓ | |
| Displays total force | ✓ | |
| Low alarm can be disabled | ✓ | |
| High & low set point display switch | ✓ | |
| Excellent electrical noise rejection | ✓ | |
| Capacity alarm | ✓ | |
| Four or six digit display | ✓ | |
| One or two sensor inputs | ✓ | |
| Analog output jack | ✓ | |
| Bi-directional RS-485/232 interface | ✓ | |
| Automatic Zero Balance | ✓ | |
| Use with load cell or T400 sensors | ✓ | |
| Autolearn | ✓ | |
| Part counter | ✓ | |
| Reverse load display | ✓ | |
| High Immediate | ✓ | |
| Time based signatures | ✓ | |
| Pressroom networking | ✓ |
| No. Of Channels | One |
| Sensor Inputs | Full bridge strain gauge sensors 120 to 1000 ohms Up to (2) 350 ohm sensors |
| Sensor Excitation | Built-in 5VDC @ 70mA max (Short circuit protected) |
| Balance Range | +/- 1mV/V of offset |
| Gain Range | Low Gain = 0.568mV/V to 5.000mV/V High Gain = 0.057mV/V to 0.625mV/V |
| Analog Output | 35mm stereo phono jack 2.5VDC @ Press Capacity |
| Accuracy | +/- 1% of full scale max |
| Non-linearity | +/- .1% of full scale max |
| Frequency Response |
Flat DC to 1KHz |
| Display | 4 or 6 digit display |
| Display Update | Every Stroke (up to 2 updates per second max) |
| Resolution | 1024 or 2048 count |
| SPM | 400 SPM (threshold trigger) 2000 SPM (probe trigger) |
| Calibration Shunts | 1 Meg Ohm .1% precision resistor |
| Computer Interface |
RS-485 |
| Trigger | Probe or Threshold |
| Threshold Probe | Built-in voltage source (12VDC @ 50mA max) provides power for NPN or PNP proximity probes. Also supports limit switch, solid state or mechanical relays |
| Resolver Interface | No |
| Shutdown Relay | 7.5A @ 120VAC N.O. and N.C. Contact Bypass switch available |
| Power Req. | 18 Watts max, 85-140VAC @ 50-60Hz OR 170-280VAC @ 50-60Hz |
| Operating Temp. | 0-70 degrees Celsius |
| Weight | Approximately 7.5lbs |
| Width | Height | Depth | |
| Dimensions | 4.33 " | 6.06 " | 7.52 " |
| Name | Format | Link |
| User Manual |  |
| Type | Name | Description | Link |
| Standard Product | PM Kit | PM Kit includes strain gauge sensors, cables and mounting hardware |
|
| Service | Installation | On-site product installation |
|